![](/uploads/1/2/7/5/127563340/620830724.jpg)
![Mac pro 2013 ssd adapter Mac pro 2013 ssd adapter](/uploads/1/2/7/5/127563340/991748449.jpg)
Find many great new & used options and get the best deals for 512gb NVMe SSD for Apple MacBook Pro Air Mac Pro 2013-17 SSUAX SSUBX 500gb at the best online prices at. By default, all Cylinder Mac Pro models are configured with a single 256 GB SSD storage module, and Apple offers upgrades at the time of system purchase to 512 GB or 1 TB of flash storage for an additional US$300 or US$800, respectively.
. Before you open your Mac Pro, shut it down by choosing Shut Down from the Apple () menu. If the computer is warm to the touch, wait approximately 5-10 minutes for the computer to cool down. Touch the metal enclosure on the outside of the Mac Pro to discharge any static electricity.Important: Always discharge static before you touch parts or install components inside your Mac Pro. To avoid generating static, don't move around the room until you finish installing the flash storage device and slide the enclosure back onto the computer. Unplug all the cables and the power cord from your Mac Pro. Do not attempt to install flash storage while the Mac Pro is plugged in.
![Macbook Macbook](http://i.ebayimg.com/images/i/251401716242-0-1/s-l1000.jpg)
Slide the enclosure latch to the right to unlock the enclosure. Next, lift the enclosure straight up and off the computer and carefully set it aside. The flash storage device (A) is attached to the graphics board by a T8 Torx screw. Using a T8 screwdriver, remove the screw that secures the flash storage device to the graphics board. Do not let the screwdriver make contact with other areas of the graphics board or damage may result. Place the T8 Torx screw in a safe place.
You will need it when installing other flash storage. With one hand, gently hold the sides of the flash storage device and gently lift it straight up to disengage it from the flash storage connector located at the bottom of the device. Once disengaged from the flash storage connector, pull the flash storage device away from the graphics board and place it into an electro-static discharge (ESD) protective bag. DO NOT pull the flash storage device away from the graphics board until it has completely disengaged from the flash storage connector or you may damage the connector.
Before reinstalling the replacement flash storage, carefully inspect the connector. The flash storage is keyed with a thin slot that connects with the flash storage connector to prevent incorrect installation.
Orient the flash storage so that it will connect with the flash storage connector. While holding the flash storage parallel to the graphics board, place the flash storage contacts into the graphics board flash storage connector. Gently push down until it is fully seated. Do not force the flash storage device into position. If the flash storage device doesn't appear to fit, verify that you are using a compatible device, and that the key on the flash storage device is oriented correctly to connect with the flash storage connector on the graphics board.-. With the flash storage device in place, carefully install the T8 screw that you removed earlier. Do not let the screwdriver make contact with other areas of the graphics board or damage may result.
![](/uploads/1/2/7/5/127563340/620830724.jpg)